FAQ

Home page

FAQ

Chartplotter

AIS

Autopilot

Radar

Fishfinder

Multi-function Display (MFD)

NMEA Devices

AIS

What should I pay attention to when upgrading the KS-200A+?

Please note the following before and during the upgrade process:

Before upgrading, log in to the KS-200A+ web configuration interface and make sure the AIS Connection Status shows OK.
For version V1.7.2 and earlier, disconnect the N2K cable before starting the upgrade. Reconnect the N2K cable only after the upgrade has been completed successfully.
If you are upgrading from version V1.3.5 or earlier to a version later than V1.3.13, you must first upgrade to V1.3.13 as an intermediate version, and then upgrade to the higher version.
Do not interrupt the upgrade process under any circumstances.

What should I do if I forget the Wi-Fi name or password of the KS-200A+?

You can reset the Wi-Fi settings by performing a hardware reset:

Use a screwdriver to remove the screws on the back cover.
Connect the power supply, then separate the front and rear housing.
Press and hold the reset button for 5 seconds until all three indicator lights flash three times simultaneously.

Once completed, the Wi-Fi name and password of the KS-200A+ will be reset.

Does the KS-200A+ support receiving GNSS data input through NMEA?

The KS-200A+ AIS transponder features a built-in GNSS positioning module and must be connected directly to a GNSS antenna to obtain positioning signals. It does not support receiving external GNSS data input through the NMEA interface.

Can the KS-200A+ receive NMEA 0183/NMEA 2000 data from other devices and forward it via the serial port or Wi-Fi?

The KS-200A+ is an AIS transponder with NMEA 2000 (N2K) data forwarding capability. It can only forward its own AIS data and GPS positioning data to external devices through the N2K interface or Wi-Fi port. It does not support receiving or processing input data from external devices.

How do I view AIS data from KS-200A+ in Navionics?